Deck stair tread-board quantity calculator

Deck / Quantity

Estimate tread-board cut pieces and net linear footage from a known stair layout and finished tread depth.

Enter your inputs

A worked project example is loaded and calculated automatically. Replace the values with your project inputs.

Input notes

Start from a known stair layout. Finished tread depth is the front-to-back coverage dimension. The gap applies only between adjacent boards. Cut length is the stair width; net footage excludes waste, kerf, edge allowances and stock-board planning.

treads
Use a whole number.
in
Enter finished tread depth in inches.
in
Enter actual board width in inches.
in
Enter gap between boards in inches.
in
Enter stair width in inches.

About this calculator

Tread takeoff counts boards across the known finished depth for each tread, then multiplies by the stair width for cut length and total footage.

Steps

  1. Known tread count

    Use a whole number.

  2. Finished tread depth

    Enter finished tread depth in inches.

  3. Actual board width

    Enter actual board width in inches.

  4. Gap between boards

    Enter gap between boards in inches.

  5. Stair width

    Enter stair width in inches.

Formula

pieces per tread = ceil((finished tread depth + inter-board gap) ÷ (actual board width + inter-board gap)); total pieces = treads × pieces per tread; cut length = stair width; net linear feet = total pieces × stair width ÷ 12.

Notation: ceil rounds up to the next whole number.

Interpret the result

The output is geometric cut-piece quantity and net linear footage. Waste, kerf, edge allowances, risers, and stock-board optimization are not included.

Worked example

Each tread needs ceil((11.25 + 0.25) ÷ (5.5 + 0.25)) = 2 pieces. Six treads need 12 pieces at 42 in each, or 12 × 42 ÷ 12 = 42 linear ft.

Example result: 12 cut pieces

Example inputs
Known tread count
6 treads
Finished tread depth
11.25 in
Actual board width
5.5 in
Gap between boards
0.25 in
Stair width
42 in

FAQs

Does net footage include cutting waste?

No. It totals the geometric tread pieces and cut length before waste or stock rounding.

Does this include a purchase allowance?

Only allowances shown in the inputs and formula are applied. If no waste, reserve, or package field is listed, the result does not infer one.

Does this make a complete construction or product plan?

No. It calculates the listed quantities from known inputs; it does not select structural dimensions, product compatibility, or code requirements.

Additional examples and limits

Tread-board cut takeoff

For 6 known treads, 11.25 in finished depth, 5.5 in actual board width, 0.25 in between-board gap and 42 in stair width: ceil((11.25 + 0.25) ÷ (5.5 + 0.25)) = 2 pieces per tread. That gives 12 cut pieces, each 42 in long, or 42 net linear ft.

Boundary: one 5.5 in deep tread covered by one 5.5 in board needs one 42 in piece, or 3.5 net linear ft. One board has no inter-board gap. An 11.2500001 in finished depth with the same 5.5 in boards and 0.25 in gap needs three pieces per tread. No waste, kerf, edge clearance, risers, stringers, retail stock-board rounding or cut optimization is included.